TightAV EXT-H102UETH-HDBT | Uncompressed 18G HDMI 2.0 Extender Set Over HDBT3 With USB 2.0 and 1G Ethernet
Hinnat näkyvät vain verkkokauppaan kirjautuneille käyttäjille.
|
|
TightAV EXT-H102UETH-HDBT | Uncompressed 18G HDMI 2.0 Extender Set Over HDBT3 With USB 2.0 and 1G Ethernet
Tuotekoodi:
EXT-H102UETH-HDBT
|
The EXT-H102UETH-HDBT is a high−performance HDBaseT 3.0 extender set for un-compressed 4K60Hz 4:4:4 HDMI, USB 2.0, Ethernet, RS−232 and IR signals. It supports and can extend HDMI 2.0b, HDCP 2.3 and HDR video up to 100m over a single Category 6A solid core cable. HDBaseT 3.0 standard allows for fully un compressed 18G HDMI signal, 1G Ethernet and improved USB2.0 bandwidth to be extended. Support for bi-directional PoC allows for easy installation by applying power to either the transmitter or the receiver.
| Transmitter | Receiver |
Video |
Input | (1) HDMI IN | (1) HDBT IN |
Input Connector | (1) Type-A female HDMI 2.0b | (1) RJ45 |
Input Resolution | Up to 4K@60Hz 4:4:4 | Up to 4K@60Hz 4:4:4 |
Output | (1) HDBT OUT, (1) HDMI LOOP OUT | (1) HDMI |
Output Connector | (1) RJ45, (1) Type-A female HDMI | (1) Type-A female HDMI |
Output Resolution | Up to 4K@60Hz 4:4:4 | Up to 4K@60Hz 4:4:4 |
Audio |
Input | - | (1) ARC IN |
Input Connector | - | (1) Toslink Connector |
Output | (1) ARC OUT, (1) AUDIO OUT | - |
Output Connector | (1) Toslink connector (1) 5-pin terminal block | - |
Audio Format | Toslink (ARC): PCM, Dolby Digital, DTS 5.1CH 5-pin terminal block: PCM 2CH |
Frequency Response | 20Hz ~ 20KHz, ±3dB |
Max Output Level | 2.0Vrms ± 0.5dB. 2V = 16dB headroom above -10dBV (316mV) nominal consumer line level signal |
THD+N | < 0.05% (-80dB), 20Hz~20KHz bandwidth, 1kHz sine at 0dBFS level (or max level) |
SNR | > 85dB, 20Hz-20kHz bandwidth |
Crosstalk Isolation | > 70dB, 10kHz sine at 0dBFS level (or max level before clipping) |
L-R Level Deviation | < 0.3dB, 1kHz sine at 0dBFS level (or max level before clipping) |
Frequency Response Deviation | < ± 0.5dB, 20Hz – 20kHz |
Output Load Capability | 1KΩ and higher (Supports 10x paralleled 10KΩ loads) |
Stereo Channel Separation | >70dB@1KHz |
Control |
Control Part | (4) DEVICE, (1) HOST, (1) USB Switch, (1) IR IN, (1) IR OUT, (1) RS232, (1) ETHERNET | (4) DEVICE, (1) HOST, (1) ARC Switch, (1) USB Switch, (1) IR IN, (1) IR OUT, (1) RS232, (1) ETHERNET |
Control Connector | (4) Type-A USB 2.0, (1) Type-B USB 2.0, (1) 2-pin DIP Switch, (2) 3.5mm Jacks, (1) 3-pin Terminal Block, (1) RJ45 | (4) Type-A USB 2.0, (1) Type-B USB 2.0, (1) 3-pin DIP Switch, (1) 2-pin DIP Switch, (2) 3.5mm Jacks, (1) 3-pin Terminal Block, (1) RJ45 |
General |
HDCP Version | Input: HDCP 2.3, HDCP 2.2, HDCP 1.4 compliant Loop out: Follows the display’s HDCP version. RX Output: Follows the source’s HDCP version. |
CEC | Pass-through (when ARC switch is selected to PASS or SPDIF) |
Bi-directional PoC | Supported |
HDMI 2.0 Cable Length | 4K@60Hz 4:4:4 ≤ 5m, 4K@60Hz 4:2:0 ≤ 15m, 1080P ≤ 20m |
Transmission Distance | 4K/1080p ≤ 100 meters (328 feet) |
USB 2.0 Bandwidth over HDBaseT | Up to 272Mbps |
Operation Temperature | -5 to +55℃(+23° to +131°F) |
Storage Temperature | -25 to +70℃(-13° to +158°F) |
Relative Humidity | 10% to 90%, non-condensing |
Power Supply | Input:100V~240V AC; Output:24V DC 1.25A |
Power Consumption | 17W(Max) |
Dimension (W*H*D) | 212mm x 25mm x 100mm |
Net Weight | 570g(TX), 555g(RX) |
Note: Please use high-qualified HDMI cable fully compliant with HDMI v2.0 for reliable transmission and connection.
Huomioi, että kuva on suuntaa-antava ja varsinainen tuote saattaa ulkoasultaan poiketa tuotekuvasta (esim. tietokoneisiin ei välttämättä sisälly näyttöä, vaikka kuvassa sellainen olisikin). Jos tuotenimikkeessä on eri tiedot kuin tuotekuvauksessa, tuotenimikkeen tieto on oikein. Jos jokin asia jää epäselväksi, lähetä sähköpostia tukeen ennen tuotteen tilaamista.